Preparation for Use
MOBILE WORKSTATION WM-DP1
18
4.8 Fitting the MAJ-181 restrictor
This procedure is only applicable if fitting a MAJ-181 LCD monitor arm to the WM-DP1 workstation.
WARNING
• If using a MAJ-181 on the workstation, the restrictor supplied in this kit
must be fitted to the MAJ-181 and is best assembled with the MAJ-181
in position on the workstation.
• To maintain stability, before installing a second MAJ-181, ensure the first
is assembled with the restrictor fitted.
• Read the instruction manual supplied with the MAJ-181, it contains
important information regarding proper care and use of the equipment.
• The WM-DP1 should be used in accordance with the following.
Otherwise, the workstation will be ‘top heavy’ and may lose stability and
topple, causing equipment damage and/or personal injury.
- Two MAJ-181 restrictors are supplied which must be fitted to
MAJ-181 LCD monitor arm(s) if used.
- LCD monitor arms and monitors should be installed after all
other equipment is installed on an appropriate place on the
workstation.
- LCD monitor arms should not be installed or used to the rear
of the workstation, see Figure 2.1.
- Confirm that the workstation does not lose stability when the
monitor arm is extended. If the workstation looks unstable,
relocate heavy equipment from the upper shelf to the bottom
shelf.
1.
Referring to the MAJ-181 instruction manual, relocate the clamp support to another fixing
hole in the support tube (see Figure 4.8) as the restrictor will be fitted through the top hole,
then insert the MAJ-181 into the monitor port in the top tray of the workstation.
