Olympus UWIT-Y0001-RX, Operation Manual

Page: 35 / 62

4.1 Inspection of the power supply
31 UWIT-Y0001-TX, UWIT-Y0001-RX INSTRUCTION MANUAL
Ch.4
Chapter 4 Inspection
Prepare the Wireless Image Transmitter Unit and other ancillary equipment before each particular
case. Refer to the respective instruction manuals for each piece of equipment.
WARNING
• Review Chapter 3, “Installation and Connection” thoroughly, and prepare the
instruments properly before inspection. If the equipment is not properly prepared
before each use, equipment damage, patient and operator injury and/or fire can
occur.
• Before each case, inspect the Wireless Image Transmitter Unit as instructed below.
Inspect other equipment to be used with this Wireless Image Transmitter Unit as
instructed in their respective instruction manuals. Should the slightest irregularity
be observed, do not use the Wireless image transmitter unit and see Chapter 7,
“Troubleshooting”. If the irregularity is still observed after consulting Chapter 7,
contact Olympus. Damage or irregularity may compromise patient or user safety
and may result in more severe equipment damage.
Power indicator lights on when the Wireless Transmitter or Receiver is powered. If power indicator
doesn’t light on, check the equipment as follows;
4.1 Inspection of the power supply
Confirm that the AC cord, AC adaptor, and the Wireless Transmitter or Receiver are
connected as described in Section 3.4, “Connecting AC adaptor to Wireless
Transmitter or Receiver” and in Section 3.5, “Connecting AC adaptor to an AC mains
power supply”.