Olympus T-10, Instruction Manual

Page: 40 / 71

40
EN
Even if a computer has USB ports, proper operation
is not guaranteed in the following cases.
computers with USB ports installed using an
expansion card, etc.
computers without a factory-installed OS and
home-built computers
Turning on the camera with the Turning on the camera with the
q q
button [ button [
q q
POWER ON] POWER ON]
r
(Settings 1) X
q
POWER ON
Submenu 2 Application
NO
The camera is not turned on. To turn
on the camera, press the
n
button.
YES
Press and hold the
q
button to turn
the camera on in playback mode.
Saving the mode when the camera is Saving the mode when the camera is
turned off [KEEP
turned off [KEEP
K K
SETTINGS] SETTINGS]
r
(Settings 1)
X
KEEP
K
SETTINGS
Submenu 2 Application
YES
The shooting mode is saved when
the camera is turned off and is
reactivated the next time the camera
is turned on.
NO
The shooting mode is set to
P
mode
when the camera is turned on.
●
●
Setting the operation sound [BEEP] Setting the operation sound [BEEP]
r
(Settings 1) X BEEP
Submenu 2 Application
OFF/ON
Turns off or on the operating
sound/warning sound of the camera
buttons.
Adjusting the CCD and the image Adjusting the CCD and the image
processing function [PIXEL MAPPING]
processing function [PIXEL MAPPING]
r
(Settings 1) X PIXEL MAPPING
This function has already been adjusted at factory
shipping, and no adjustment is needed right
after purchase. Approximately once a year is
recommended.
For best results, wait at least one minute after taking
or viewing pictures before performing pixel mapping.
If the camera is turned off during pixel mapping, be
sure to perform it again.
To adjust the CCD and the image To adjust the CCD and the image
processing function
processing function
Press the H button when [START] (Submenu 2) is
displayed.
The camera checks and adjusts the CCD and the
image processing function at the same time.
Adjusting the brightness of the monitor Adjusting the brightness of the monitor
[[
s s ]]
s
(Settings 2) X s
Submenu 2 Application
BRIGHT/
NORMAL
Selects the monitor brightness
depending on the surrounding
brightness.
●