5
Getting Started
Before you can use your R1018, perform these
basic setup procedures:
•
Charge the battery
•
Start the R1018
Charging the Battery
Before using your R1018 for the first time, charge
the built-in Lithium-Polymer battery for about 3
hours using the USB Sync Cable with AC
Adapter attached. Follow these same procedures
to recharge the battery.
When the battery is fully used up, charge within
72 hours to prevent any data loss.
•
Connect the AC Adapter to the USB Sync
Cable.
•
Insert the USB Sync Cable to the
Communication Port found at the bottom of
the R1018.
•
Plug the AC Adapter into a wall outlet and
turn on a wall outlet, if applicable.
•
The Terminal Status LED turns RED to
indicate charging.
•
The LED will turn GREEN after the battery is
fully charged. This will take approximately 3
hours.
Starting the R1018
Press the Power Button to turn the R1018 on or
standby. In case where the Power Button is
pressed for the first time, the booting splash
screen will be displayed for about 30 seconds.