50
Chapter 5 Operation
ELECTROSURGICAL UNIT PSD-30
Retrieving the output setting, cut mode and coagulation
mode
1.
Press the program switch, when the electrosurgical unit is turned ON and
the cut mode and coagulation mode indicators are flashing (see Figure 5.7).
The stored cut mode, coagulation mode and output setting will be displayed
and a short beep is generated (see Figure 5.8).
Figure 5.7
Figure 5.8
2.
If the program switch is pressed and no settings are stored in the memory,
an error message “EE” will be displayed on the coagulation output setting
indicator. Perform setup as described in Section 5.2, “Selection of cut
mode”, Section 5.3, “Selection of coagulation mode” and Section 5.4,
“Setting output”.