OLYMPUS Industrial Web Printer Operation Guide Rev.001 14/19
tape tightly.
11) Turn
the
Mode SW
of the
Unwinder Control Box
to the
Low Speed Drive Mode
.
12) Push
the
Low Speed Drive
button of the
Unwinder Control Box,
then roll paper will be driven
slowly until the connected position will be exited from the
Paper Exit
.
13)
Turn the Mode SW of the Unwinder Control Box to the Print Mode position, then the machine is
ready to print.
NOTE: Data of incomplete job will be lost. It must be reprint.
1.4.3.
Change of the Paper Cut Size
1) Set two blades when size of the desired output paper is LETTER/A4.
2) Set one blade when size of the desired output paper is LEDGER/A3.
3) Make sure to use the proper position of the blade for LEDGER/A3, otherwise output paper will not be cut
properly.
4) Select the lever of
Paper Exit
unit for the proper paper size.
5) Select the proper paper size on the T
ouch Panel
. (It is not necessary to set the
operation panel
.)
NOTE: Refer to EXHIBIT D PINNACLE DIE CUTTER for the detail.
