![background image](http://html.mh-extra.com/html/olympus/e-pm2/e-pm2_instruction-manual_734335110.webp)
110
EN
Information
10
3
Adjust the settings for each group in the super control panel.
Flash intensity
value
250
250 F5.6 0.0
0.0
P
38
38
A Mode
TTL
M
Off
+5.0
TTL
+3.0
1/8
–
LO
1
Ch
Group
• Select the
fl
ash control
mode and adjust the
fl
ash
intensity separately for
each group. For MANUAL,
select the
fl
ash intensity.
Normal
fl
ash/Super FP
fl
ash
• Switch between normal
fl
ash and Super FP
fl
ash.
Communication light level
• Set the communication
light level to [HI], [MID],
or [LO].
Channel
• Set the communication
channel to the same
channel used on the
fl
ash.
Flash
intensity
Flash control
mode
Adjust settings for the
camera
fl
ash unit.
4
Attach the supplied
fl
ash unit and raise the
fl
ash head.
• After con
fi
rming that the built-in and remote
fl
ash units have charged, take a test shot.
Wireless
fl
ash control range
Position the wireless
fl
ash units with their remote sensors facing the camera. The following
illustration shows the approximate ranges at which the
fl
ash units can be positioned. The
actual control range varies with local conditions.
7m
5m
100°
100°
50°
50°
50°
50°
60°
60°
30°
30°
30°
30°
#
Cautions
• We recommend using a single group of up to three remote
fl
ash units.
• Remote
fl
ash units cannot be used for second curtain slow synchronization or anti-shock
exposures longer than 4 seconds.
• If the subject is too close to the camera, the control
fl
ashes emitted by the supplied
fl
ash
may affect exposure (this effect can be reduced by reducing the output of the supplied
fl
ash by, for example, using a diffuser).
• The upper limit of
fl
ash synchronization timing is 1/160 sec. when using the
fl
ash in
remote control mode.
Other external
fl
ash units
Note the following when using a third-party
fl
ash unit mounted on the camera hot shoe:
• Using obsolete
fl
ash units that apply currents of more than about 24 V to the camera hot
shoe X-contact will damage the camera.
• Connecting
fl
ash units with signal contacts that do not conform to Olympus speci
fi
cations
may damage the camera.
• Use only with the camera in shooting mode
M
at shutter speeds slower than 1/160 s and
at ISO settings other than [Auto].
• Flash control can only be performed by manually setting the
fl
ash to the ISO sensitivity
and aperture values selected with the camera. Flash brightness can be adjusted by
adjusting either ISO sensitivity or aperture.
• Use a
fl
ash with an angle of illumination suited to the lens. Angle of illumination is usually
expressed using 35-mm format equivalent focal lengths.
Summary of Contents for E-PM2
Page 131: ...131 EN V Video Out 72 W WB 49 75 ...