![background image](http://html2.mh-extra.com/html/olympus/dp21-sal/dp21-sal_instructions-manual_4070665015.webp)
12
DP21-SAL
Fig. 1
1
Installing the Control Box D21-CB
(Fig. 1)
}The control box D21-CB can be installed either horizontally or vertically.
}Do not place a heavy object weighing over 10 kg or an object that would
make the installation unstable on the control box D21-CB.
Horizontal installation
Place the control box D21-CB on the desktop so that its rubber feet
contact the desktop surface.
Vertical installation (Fig. 1)
Attach the stabilizer @ provided with the control box D21-CB on the side
of the control box D21-CB using the provided screws ².
Always use the provided stabilizer for vertical installation.
2
Connecting the Camera Cable
(Fig. 2)
· The cords and cables are vulnerable to bend or twist. Do not
apply excessive force to them.
· Be sure to switch off the control box D21-CB before proceeding
to the connection.
NOTE
When connecting the cable, insert the connector plug in
the proper direction.
(Example: Camera cable)
Cable side
Connector side
Fig. 2
1. Insert the connector @ on one end of the camera cable into the connec-
tor ² on the camera head.
2. Insert the connector ³ on the other end of the camera cable into the
connector | on the control box D21-CB.
}When you connect the microscope digital camera DP21/DP26 to the
control box D21-CB, the microscope digital camera DP21/DP26 is recog-
nized automatically. It is not required to perform any configuration or so
after connection.
1
2
1
2
³
|
CAUTION
INSTALLATION
This section describes only the procedures to mount the control box D21-CB. For detail descriptions of the microscope,
the camera head or the camera adapter, etc. to be used together, refer to the relevant Instruction Manual, and assemble
them with careful attention.
Downloaded from