Maintenance manual
Adjustments
2-1
Page
2 Adjustments
2-1 Registration of Inspection Wafer by Type
The loader requires adjustments when the cassette is changed or the thickness of the wafers to be
inspected is changed.
If the loader is used without any adjustment to the proper state, it may give damage
to wafers. Receive the training of loader maintenance before making adjustments.
To prevent danger, be sure to turn the main switch OFF and disconnect the power
cord before removing the cover for adjustment work.
1 Registration of a New Type of Inspection Wafer (Cassette to be Used and Wafer
Thickness)
1-1. Main Operating Procedure
Prepare the cassette and wafer to be registered, and adjust and register them using the following procedure.
1) Activate adjustment test mode
2) Test 24 wafer type setting registration
3) Test 11 wafer mapping parameter setting registration
Items to prepare Insert the wafers to be registered in the lowest and highest slots of the cassette.
4) Test 11 wafer mapping parameter confirmation
Items to prepare Insert the wafers of the same thickness to be confirmed into all slots of the cassette.
5) Test 12 A-arm height (arm insertion and removal height) setting registration
Items to prepare Insert the wafers of the same thickness to be confirmed into all slots of the cassette
6) Quit adjustment test mode
1-2. Operating Procedure
1) Activate adjustment test mode
Turn the main switch OFF.
Turn the main switch ON while pressing the Wafer No. selector buttons [1] and [2].
2) Wafer type setting registration
Using Test 24, specify the wafer size, thickness, transfer speed, comment to be registered.
①
Press the Wafer No. selector button [24], then press the [Start] button.
②
The wafer types currently registered are displayed on the liquid crystal
panel.
Using the 4-way button, move the <x> to the item to add or change or
deletion, then press the 4-way button [RIGHT].
③
Specify the following items.
•
Wafer size <Size>
: Select one of 300/---
•
Wafer thickness <Thick> : Select one of 775-500/500-200
•
Transfer speed <Speed> : Select one of Fast/Middle/Slow/SP1–SP5
•
Comment <Comment> : Input of a maximum of 16 characters is
possible.
* Refer to Section 4 Test Mode for detailed procedures.
* There is a limit to selectable items, depending on the specifications of
the loader.
* When chose --- with a wafer size <size> column, the set point is
deleted, and it is not displayed to a wafer type screen at the time of
the inspection.
No |Size |Thick
|Speed |comment
x1 | 300 |775-500 |High
|
2 | 300 |775-500 |High
|
3 | 300 |775-500 |High
|
4 | 300 |775-500 |High
|
5 | 300 |775-500 |High
|
6 | 300 |775-500 |High
|
OK
Cancel PageUp PageDn
No |Size |Thick
|Speed |comment
x1 | 300 |775-500 |High
|
2 | --- | |
|
3 | --- | |
|
4 | --- | |
|
5 | --- | |
|
6 | --- | |
|
OK
Cancel PageUp PageDn
*Indication example when
registering only one kind
CAUTION
Summary of Contents for AL120-12 Series
