Olympia RTX 200, Operating Manual

Page: 22 / 29

Installation
21
G
Installation Steps
Proceed as follows to install the smoke detector:

WARNING!
Risk of serious injuries through damaging cables or pipes!
During installation, pay attention to the possibility of cables and pipes running in the walls and
ceilings. We are not deemed liable for installation errors.
If in doubt, contact a specialist!
1. Ensure that there are no electric cables, gas or water pipes near the installation location.
2. Screw the base (1) to the ceiling at the chosen installation location using two screws approx.
80 mm apart. (If necessary, use dowels as additional fixation material.)
3. Ensure that all the smoke detectors in are connected by the way and means necessary for your
configuration (refer to Section Registering ).
4. Install the smoke detector on the base (1) and screw the smoke detector in the direction of the
arrow until it audibly locks in place.
You can only install the smoke detector on the base when a battery has been inserted in the
battery compartment on the rear of the smoke detector.
Disassembly of the smoke detector is performed in the reverse sequence.