Olympia RTX 200, Operating Manual

Page: 13 / 29

Registering Without Alarm System
12
G
Setting Up a Smoke Detector as Master
The master should be set-up in a central position in the area to be monitored. The Code button must
remain pressed until the registration process, including all of the slaves, has been completely fin­
ished.
1. Connect the 9 V power pack enclosed in the scope of delivery to the battery clip on the smoke
detector. The battery clip is reverse-polarity proof.
2. Press and hold the Code button (2) on the rear side of the smoke detector until the entire registra­
tion process is completely finished.
3. The alarm signal sounds, the smoke detector is set-up as the master.
Registering the Smoke Detector as a Slave
Further smoke detectors can be registered as slaves directly on the master.
Slaves should also be installed as centrally as possible in the area they must monitor.
A condition for registering smoke detectors as slaves is that one smoke detector is already
registered as a master.
1. Connect the 9 V power pack enclosed in the scope of delivery to the battery clip on the smoke
detector. The battery clip is reverse-polarity proof.
2. Press the Code button (2) on the rear side of the smoke detector.
3. The alarm signal sounds, the smoke detector is set-up as a slave.