Olympia MILLENNIUM H, Owner'S Manual

Page: 87 / 113

The Ultimate Ice Resurfacer 75
MILLENNIUM
H
7.4 Resurfacing Procedure
Once you have taken on sufficient water (10 % more than needed to do a single resurfacing),
before driving onto the ice surface, turn on the tire wash to rinse the tires of any debris. With
the tire wash water turned off, carefully drive onto the ice surface and carry out the normal
ice making procedure as follows:
• Lower the conditioner to the ice surface by pushing the bottom of the conditioner switch
until the conditioner lift arms are all the way down.
• Engage both the vertical and the horizontal augers by pushing the bottom of the elevator
on switch.
• Turn on the ice making water with the manually operated water valve.
• Turn on the Wash Water following the previous instructions (first the wash water hand valve
and then the wash water pump).
• Now engage the board brush by pushing the bottom of the board brush switch.
• Drive slowly ahead keeping the board brush against the boards. (This will clean the snow on
the kick plate and edges of the ice surface into the conditioner)
• Upon completion of a full circuit of the rink, retract the board brush by pushing and holding
the board brush switch and follow the pattern shown below.
Use extreme caution with the board brush when passing open gates as the board brush could
swing into the opening, causing damage to both the boards and/or the ice resurfacer.