Operating Instructions
CM 701 / 702 / 711 / 712 Cash Register
Programming Instructions
Olympia 8.2005
Page 7
All Rights Reserved
2
Inserting a paper roll
Remove the printer lid. Insert a paper roll of 57 mm width and max. 70 mm diameter. Do not use recycled
paper because this causes the printer to wear more quickly. Prepare the paper roll for insertion. Feed the end
of the paper roll, which has been cut straight, into the printer mechanism and press the
P
key until approx. 10 cm of it
has been transported. Depending on the intended use (calculator or journal mode), thread the paper strip through the
slot in the printer lid and tear off the paper strip on the lid's tear-off edge. In the case of journal mode, thread the paper
strip in the paper reel. Replace the printer lid.
3 Paper
reel
The paper reel is required when the receipt should be wound onto it.
Change the system setting no. 18 to 1.
1. Open the printer lid.
2. Remove the paper reel.
3. Thread the end of the journal paper in the slit in the paper reel.
4. Insert the paper reel in the reel guides provided for it.
5. To remove the journal paper after it has been rolled up on the reel, remove the
paper reel and pull the journal roll off.
6. Reinsert the paper reel.
7. Close the printer lid.
4 Inserting
batteries
Note: Insert batteries to ensure that all the data is retained in the event of a power failure.
1. Open the printer lid.
2. Open the battery compartment cover (black flap) in the paper compartment.
3. Insert three AA round cell batteries.
Important: Pay attention to the correct position of the batteries
(refer to diagram and / or identification).
4. Close the battery compartment cover.
5. Close the printer lid.
6. To ensure data retention, replace the batteries once a year with the cash register
switched on.
