41
921468007_09_010
WARNING! The latest version of the software PC-468 is available in the following web address:
http://www.olympia-electronics.gr
The panel or the keypad must not be connected to the computer during the software installation. The
PC-468 installation is done automatically by inserting the CD in the drive or by running the file BS-
468_setup_vx.x.xx, found in the installation CD. After installation ends, connect the USB cable to the
USB port of the BS-466/A keyboard or BS-468/A board in order to establish a connection with the
panel.
The first time we connect the keyboard or the panel to our PC, we have to wait for the drivers to be
installed properly. If we accidently open the PC program before the drivers' installation is finished, and
the communication indicator is red instead of green (see first picture on the next page) we must close
the PC program, unplug the USB cable and insert it again. After the drivers finish the installation pro-
cedure, we can start the software again.
When the program starts there are 2 options:
1) Online Operation (BS-468/A connected)
2) Offline Operation (New file creation)
Online Operation
First connect the mini-USB cable to a BS-466/A keyboard or the USB Type-B cable on the board. The
two modes of connection are shown in the above photos.
Launch the BS-468 program on the PC. After a short startup screen, we see the home screen. Com-
munication lights in the bottom left corner must be green. The bottom indicator is not permanently
green, but it flashes when the panel sends data to PC.
