18
Cold Laminating
1. Connect the power cable to an easily accessible, standard electrical
socket.
Attention:
Check that the voltage specifications of the machine corre-
spond to that of your power supply network
(220-240 V / 50 Hz).
2. Switch on the
power switch
on the rear side of the device.
3. Press
the
On/Off button
on the operating panel to switch the device on.
The drive motor for the transport rollers starts up.
4. Press
the
button for selecting cold/hot laminating and foil thickness
, sev-
eral times if necessary, until the COLD LED lights up in the operating
panel. The LED strip lights up blue, continually, when the device is
ready for use.
Attention:
If you have just finished using the laminator for hot laminat-
ing, you must let the laminator cool down. The equipment
takes about 30 minutes to cool down. The LED strip flashes
red during the cool down phase.
5. Insert the document to be laminated in the foil pocket so that there is a
margin of approx. 3-5 mm to the edge of the foil on all sides.
6. Insert the foil pocket containing the document in the laminator's infeed
slot. Insert the ready closed side of the foil in first. The laminating pro-
cess occurs automatically.
Note:
To prevent the foil pocket from creasing, never feed the
open side of the laminating pocket first in the infeed slot of
the laminator.
Note:
If the device remains unused for 30 minutes, it switches off
automatically. Press the
On/Off button
on the operating
panel to switch the device on again.
7. When you have finished your laminating tasks, press the
On/Off button
on the operating panel to switch the device off. Switch off the
power
switch
on the rear side of the device. Also disconnect the power plug,
particularly when the device will remain out of operation for a longer pe-
riod.
