36
5. If 32 devices have already been installed and try to add another, 4 long beeps will be heard. No
other devices can be installed.
6. By pressing the
" #
ESC
"
button, the installation procedure stops and we get back to "Wireless
Network" menu.
NOTE: For every change we make in the wireless zone menu and during the detection of extensions,
it takes time to update the wireless system data. During this process, when we try to enter a menu, a
message is displayed. When the process is complete, we can again use the menus.
Installing wireless network devices with your PC and the BS-477 Wireless Keyboard
In this case, the network installation should be done by PC-468 software. For this reason, there is a
USB connector on the BS-468/A too. The user should follow the following steps.
1. Plug the USB cable on the BS-468/A panel.
2. Open the PC-468 software and press "Scan keypads".
3. Press "Scan extensions".
4. Start "Network Setup" from the wireless tab.
As far as processes 3 and 4 are in progress, the BS-477 should not have its batteries. When the bat-
teries are loaded, the panel will recognize it and install it into its network as well as any other wireless
devices assigned to the panel. The corresponding indicator on the PC program will also be updated.
When all of the above steps have been completed, the rest of the wireless network settings can be
executed normally by the BS-477.
Wireless network installation without keyboard and PC
The procedure is simple and is realized via 2 push-buttons of the BS-479 expansion card. The pro-
cess is divided into 2 parts, the first one concerns the device detection and the second concerns the
installation of a wireless keyboard. If the BS-477 wireless keyboard is installed, the installation of other
devices can be completed by the keyboard menu. To process the procedure focus on BT1 and BT2
buttons as well as LEDs LD4 (green) and LD2 (yellow). The total process of inserting a wireless key-
board into the network lasts 2-3 minutes.
DEVICES DETECTION
First, BS-468/A should detect the BS-479 extension. It will also search in general for all connected
devices, extensions and wired keyboards. The procedure is the following:
1. Power on the panel and wait for 15 seconds to initialize. At this stage, LD2 (yellow) is lit and
LD4 (green) is off.
2. Press the BT1 button for about 3 seconds until the LD4 lights up. Then release the button.
3. Wait about 20-30 seconds until LD4 goes out, indicating that devices detection has been
completed.
4. Wait about 10-15 seconds until LD2 goes out. This means that the wireless network initializa-
tion is complete.
5. End of procedure.
WIRELESS KEYBOARD DETECTION
The batteries, of the wireless keypad that will be inserted into zone 25, should not be installed and the
tamper switch must not be pressed. Hold it in your hand and follow the steps below.
1. Press the BT2 button and wait until the LD4 (green) starts blinking as a flash (1 second on - 1
second off). Once it starts blinking, release the BT2.
