![background image](http://html.mh-extra.com/html/olt/ssgs812-fj-ply/ssgs812-fj-ply_assembly-manual_732287024.webp)
52.
With Gusset correctly positioned, attach to Rafter with 4 - 2” screws per side. Use a level to
check for square. Pilot hole end of Gussets to prevent splitting. Complete installation of remaining
Gussets.
53.
Position 3/4” x 3/4” x 44 1/2” long
Polygal Support Cleats
on each Long Rafter flush to end and
recessed 1/4” down from top of rafter. Pilot hole 1/8” in both ends and attach with 1 1/4” screws. Nail
also to rafter using 4 - finishing nails.
Note:
Start nails in Supports on ground first. Complete
remaining 11 Polygal Support Cleats.
1/4” gap
54.
Identify all
Roof Panels.
There are 4 Outside Panels and 2 Center Panels. The outside panels
are (⅝” x 48” x 37 1/2”) while the center panels are (⅝” x 45 ½” x 37 1/2”). Starting with an Outside
Roof Panel on Short Rafter Side, lift up and place on rafters so centered on mid rafter. Plywood on
roof should be flush with end of rafter at bottom.
D. Roof Section
Further secure Cleats
with 2 - 1 1/4” screws.
Important:
Drill pilot
holes to prevent splitting!
Outer Roof Panel (4)
Center Roof Panel
(2)
Polygal Roof
Panels (6)
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 24