![background image](http://html.mh-extra.com/html/olt/ssgs812-fj-ply/ssgs812-fj-ply_assembly-manual_732287022.webp)
44.
Starting with the Short Rafter Side, lift and flip completed section over so Soffit is facing down.
Slide rafter up on gable framing until bottom of Ridge Board slips into gable notch. Position rafters so
they sit evenly on Gable framing from side to side.
Slide Bottom of
Ridge Board into
notch of gable.
gable notch
45.
Where Wall and Soffit meet, a
small gap may appear. Confirm all
Rafters are resting on Top Plate.
46.
Lift and flip Long Rafter Side up and place on Gable
framing
. Make sure Metal Ridge Board Connectors of
both Roof Sections are offset. See Step 48.
47.
Slide Long Rafter Side on Gable framing so bottom of ridge board slips into Gable notch. Soffit
will sit approximately 1/8” away from wall as per
Step 45.
Bottom of Ridge Board fits in gable notch.
Top of Ridge Board will sit 1/2” lower than
short rafter side ridge board.
Important:
make
sure Metal Ridge
Board Connectors on
Long Roof Side and
Short Roof side are
offset.
See Step 48.
Slight gap between
wall and soffit.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 22