![background image](http://html1.mh-extra.com/html/olt/12x4-spacesaver-shed/12x4-spacesaver-shed_assembly-manual_3831874009.webp)
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 9
Bottom Wall Plate
You can find BR1 -
Square Drive Bit for
the screws in with the
Hardware Kit Bag.
7.
Carefully lay
2AA
- Side/Rear Wall Panels
face
down. Position and attach
2AB - Bottom Wall
Plates
to bottom of wall studs of each wall panel
with
3 - 2 1/2” Screws
. Position so plates are flush
with framing. Complete 4 remaining solid walls.
Parts
2AA - Side/Rear Wall Panels
(45 1/2” wide x 75” high)
x 5
2AB
- Bottom Wall Plates
(1 5/8” x 2 1/2” x 45 1/2”)
x 5
Hardware
S1
- 2 1/2” Screws
x 15 total
Ensure bottom plate
is flush side-to-side
with wall studs
Important:
Make sure all walls are aligned in their
upright position. If not, water may leak into your shed.
Unsure if panel is facing up or down?
Recently attached Bottom Plate is on bottom of panel.
Outside 2x3 framing of wall panel should
be positioned flush with the outside of
floor framing when properly aligned.
9.
The rear wall panels will sit even with the floor frame and the sidewall panels will be sandwiched
between the front and rear wall panels. The floor plywood may be slightly recessed.
Note:
Siding will overhang the floor frame by approximately 3/4”.
8.
Starting on one side, position a Solid Wall Panel on top of plywood floor. The Wall Panel bottom framing
will sit flush with the outside of the floor frame. Wall siding will overhang the floor.
Siding overhangs
floor frame by 3/4”
Floor plywood
may be slightly
recessed
Do Not Attach Walls
To Floor until Step 24.