![background image](http://html1.mh-extra.com/html/olt/12x4-spacesaver-shed/12x4-spacesaver-shed_assembly-manual_3831874026.webp)
Center of Battens
Note: If Top Siding Pc. for
Angle Wall was not
installed in Step 16 it can
be done now. Attach with
3 - 1 1/2” Finishing Nails
per piece.
Secure lower/front
Batten row, be careful
not to overtighten.
44.
Using
5 - 2” Metal Screws
and
1/4” Nut Driver
, secure
Metal Roof Panels
down to lower/rear
Batten
row. Tighten screws in middle
Batten
row which were
partially attached in
Step 42
. Do not overtighten!
Hardware
2” Metal Roof Screws
x 5 total
Tighten middle row, be
careful not to overtighten.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 26
43.
Before fully fastening
Metal Roof
Panels
down, remove the
Metal Roof
Hangers
and insert
Foam Enclosures
between
Metal Roof Panels
and
Battens
at
the rear/bottom. Enclosures will prevent
moisture and unwanted bugs, etc from
entering your shed from here.
Parts
Foam Enclosures
x 4 total
Remove Metal
Roof Hangers
Insert Foam
Enclosures