Oliver 758-N, User Operating Instructions Manual

Page: 21 / 51

758-N Front Load Dual-Slicer
0758S20007 6-8
Replacing the Belt (Shown using single slice thickness unit)
WARNING
ALWAYS DISCONNECT THE SLICER FROM THE POWER SUPPLY BEFORE
ATTEMPTING ANY TYPE OF MAINTENANCE TASK.
Remove the top cover by removing the six knobs which secure it. Using a wrench,
loosen but do not remove the four nuts which secure the motor mounting plate to the
machine. Move the motor and its mounting plate downward as far as it will go allowing
the belt to loosen as much as possible. (See “Tightening the Belt” section).
CAUTION
DO NOT REMOVE THE MOTOR PLATE NUTS COMPLETELY.
Disconnect the end of the connecting rod attached to the rocker by removing the two hex
cap screws and rod cap which secure the connecting rod to the rocker. Once this has
been done you should be able to remove the belt.
After replacing the belt reattach the connecting rod making sure to place the connecting
rod as perpendicular as possible to the rocker’s main shaft. Retighten the rod cap’s
bolts securely. Tighten the belt as described in the “Tightening the Belt” section of this
manual and then replace the top cover.