Oliver 758-N, User Operating Instructions Manual

Page: 10 / 51

758-N Front Load Dual-Slicer
0758S20006 5-1
TROUBLE SHOOTING
WARNING
ALWAYS DISCONNECT THE SLICER FROM THE POWER SUPPLY BEFORE
ATTEMPTING ANY TYPE OF MAINTENANCE TASK, INCLUDING
TROUBLESHOOTING.
The Slicer Will Not Start (Motor Is Not Humming)
•
The machine is not plugged in.
•
There is no power at the outlet. (Check by plugging in a small working appliance,
like a lamp. Check to see if a circuit breaker has tripped. If the circuit breaker has
not tripped and the circuit is still not working have a qualified electrician check the
circuit.)
•
The Emergency “Stop” button has been pushed. Twist the Red button in the
direction of the arrow on the button to release it to its run position.
•
The lever is not being HELD in the forward most position.
•
There are bread crumbs beneath the cradle bracket or in the cradle guide tracks at
each side of the cradle bracket preventing it from going all the way down, which it
must do before the lower limit switch can be tripped.
•
The lower limit switch is not adjusted properly. (Have a qualified service agent
adjust the switch.)
•
The lower limit switch is defective. (Have a qualified electrician check and replace
the switch if required.)
•
The problem is somewhere else in the electrical system of the machine. (Have a
qualified electrician find and repair the problem.)
Continued