MODEL 711 COUNTER TOP SLICER
0711S20006-
2
ADJUSTING THE GAS SPRING (Continued)
The pin located in the high forward position should be used when greater force is
desired as the product is first entering the knives.
Using proper gas spring installation procedures, see “Replacing a Gas Spring”, in the
maintenance section, compress the spring and mount it on the desired pin, secure it
with a new clip.
NOTE
Normally difficult cutting breads require
LESS
force at the beginning of
slicing not more.
CLEARANCE BETWEEN BLADE FRAMES
Remove the top guard, and front guard from the machine, see “Removing Blade
Frames” in the maintenance section. The distance between the top of the blade frames
is adjusted by rotating the eccentric pins located in the front of the machine. A small
screwdriver or rod must be inserted through the hole in the side of the eccentric pin to
keep the pin from rotating while loosening the locknut on the end of the pin with a
wrench. See below.
Using the small screwdriver or rod, rotate the pin to the desired position and tighten the
nut to lock the pin in place. Check the frame clearance by turning the driven pulley by
hand. When the adjustment is complete, replace the guards and table lip.
Rev. 11-30-00
