MODEL 711 COUNTER TOP SLICER
0711S20005-
7
REPLACING THE BELT
Remove the top guard and rear inspection plate from the slicer, as described under
“Tightening the Belt”. Loosen the motor mounting bolt nuts slightly (see Belt Tightening
section), and lower the motor as far as it will go. Disconnect the end of the connecting
rod at the rocker frame by removing the two capscrews and cap. See the drawing
below. You should now be able to remove the drive belt from the pulleys.
Install a new belt by reversing the removal procedure. Refer to the “Belt Tightening”
section for advice on how to adjust the drive belt tension.
REPLACING THE GAS SPRING
Remove the handle by loosening the setscrew in the hub. The handle side cover can
now be removed by removing the six slotted head screws holding it in position. See the
next illustration.
