Oliver 5018, Owner'S Manual

Page: 20 / 52

17
TO POWER
SOURCE
CONNECT POWER WIRES (1)
This machine has been factory test by using the proper voltage before
shipment. Before the machine is connected with the factory power, be sure
the power supply is the proper voltage, hertz and phase as the machine
prewired.
Connect the power wires to "R.S.T" contacts in the junction box, located at back
side of the machine cabinet. After the power wires are connected, try to start the
saw blade running by pressing the saw blade start switch, and then press the
saw blade stop switch for immediately stopping the sawblade. At this time check
to see if the sawblade runs to the correct direction as the arrow sign indicated.
JUNCTION BOX CONTROL PANEL
S A W B L A D E
S T A R T S W I T C H
SAWBLADE
STOP SWITCH
AIR POWER
SWITCH
GROUND WIRE