Oliver 5018, Owner'S Manual

Page: 30 / 52

27
ADJUSTING WORKING HEIGHT
1.
Raise the hold-down clamp by pushing in the AIR ON/OFF control collar on
the quick air connector.
2.
Place a workpiece to be cut under the hold down clamp.
3.
Turn the height adjustment knob to raise or lower the hold down clamp. If
you feel heavy to turn this knob, pull back the AIR ON/OFF CONTROL
COLLAR (air off) for effortless turning of the knob.
4. Normally the hold-down clamp is adjusted so that its bottom is about
1/4
”~3/8” above the workpiece.
5. After the hold down clamp is adjusted, tighten the lock nut.
HOLD
DOWN
CLAMP
LOCK
SCREW
LOCK
SCREW
LOCK
SCREW
LOCK
SCREW