Oliver 1708-N, User'S Operating And Instruction Manual

Page: 4 / 19

1708 SELF-ACTUATING LIDDER
4/16/96 1708S20009
SET UP
1. Unpack and carefully remove the Self-Actuating Lidder . Check for completeness of your order
and that none of the items have been damaged during shipment. Save packing material for
future shipping.
2. Place the Self-Actuating Lidder in a suitable location that provides adequate working space. The
location must be sturdy, level, and capable of holding 175 lbs. per machine. For maximum
efficency of the Self-Actuating Lidder use the Workstation Stand option.
3. Use a quick detachable coupler with one way shut-off, connect air pressure to the 1/4” NPT
female fitting located on the filter/regulator. The Self-Actuating Lidder requires a minimum of 1
CFM at 90 PSI. If needed an Air Compressor option is available for the Self-Actuating Lidder.
NOTE
•
DO NOT USE AN OILER OR LUBRICATOR WITH THIS MACHINE.
NOTE
•
DO NOT CONNECT TO AIR PRESSURE ABOVE 150 PSI.
4. Plug the power cord into a grounded electrical outlet. The Self-Actuating Lidder requires single
phase 90 to 130 VAC, 60 Hertz with 10 ampere (minimum) circuit breaker protection.
5. To install the tray carrier, completely extend the tray carrier supports to their locked position.
Position the tray carrier over the tray carrier supports with the retractable pins facing up and the
knob facing forward. lower the tray carrier into position while locating the four tray carrier holes
on the four tray carrier support pins.
6. Load and thread lid dispenser as shown below.