1708 SELF-ACTUATING LIDDER
4/16/96
1708S20010
OPERATING PROCEDURE
1.
Switch the heater power switch on by firmly pressing the “ON/RESET” button located on the
yellow power cord. A small yellow light in the center of the switch will illuminate indicating the
power is on. Wait approximately 40 minutes to allow the heated upper platen time to stabilize at
the working temperature.
2.
Place a tray in the tray carrier and position a single lid on the tray. Use the retractable pins on the
tray carrier to center the lids over the tray. Be sure the adhesive side of the lid is against the tray
.
NOTE
•
The adhesive side of the lid can be determined by pinching a fold and rubbing the lid material
against itself. Test both sides of the lid. The rough or tacky side of the lid will be the adhesive
side.
3.
Push the tray carrier into the
Self-Actuating Lidder
until it stops. This will cycle the heated upper
platen down, applying pressure on the film and tray flanges. As the heated upper platen lifts back
to the open position, the tray carrier will automatically reopen.
4.
Remove the lidded tray by rotating the knob on the front of the tray carrier.
Summary of Contents for 1708-N
