Olimpia splendid LIMPIA 2, Instructions For Use And Maintenance Manual

Page: 20 / 52

ENGLISH
20
PROBLEM SOLUTION
Water vapor and humidity are
not produced.
•
Power plug: Unplug and then try again.
• Power Failure: When the power is returned, try again.
• Tank Installation: Make sure the tank is correctly attached.
• The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
Air blows but water vapor is not
produced.
• Excessive Water: Remove a certain amount of water from the tank.
• Detergent residue and/or oil ingredients from cosmetics, etc may be in tank;
wash out tank and try again.
• The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
• If you use hard water, replace with softer water.
Humidity level is low. •
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk.
• The water in the unit is too cold: Replace with cool, but not cold water.
The humidity has a bad smell. • Poor maintenance or dirty water: Clean the product thoroughly, and fill it with
fresh water.
White dust is forming on nearby
furniture.
• Hard water may deposit a certain of dust. Dust in the air also settles because
of added humidity in the room. Use distilled water if this becomes a nuisance.
Unit has stopped working. • No or low water. Unplug unit and refill tank.
Water is accumulating outside of
unit or area surrounding unit.
• Saturation of humidity. Lower mist control setting.
• Unit not level and water is accumulating. Unplug and place on level surface.
Point spray away from objects. Raise unit on a water-resistant level surface
at least 60 cm from the floor.
Water dripping when refilling. • Water remaining on bottom of tank. Wipe tank or tilt to drain before
transporting.
Increased noise level. • Unit must be placed on a flat, level, hard surface. Make sure it is NOT placed
on a soft or absorbent surface.
Flashing light symbols. • Indicates low water. Unplug and refill tank.
6- TROUBLESHOOTING GUIDE