Olimpia splendid ARYAL S1 E, Instructions For Use And Maintenance Manual

Page: 83 / 320

ARYAL S1 E
ENGLISH
EN - 31
Before adjusting the vertical louvres, disconnect the electric power supply.
3.5.1 - Adjustment of the vertical direction of the air (high - low) (figure “36”)
the air conditioner automatically adjusts the vertical direction of the air, according to the operational mode.
Perform this function when the unit is operating.
Hold the “SWING” key down on the remote control (figure “34” - ref. 3) to move the louvres in the desired
direction.
•
The AIR DIRECTION and SWING buttons will be disabled when the air conditioner is not operating
(also when the TIMER ON is set).
•
Do not activate the air conditioner for long periods with the air downwards in cooling or
dehumidification modes.
Otherwise, humidity may form on the surface of the horizontal louvres, which could fall onto the
floor or furnishings.
•
Do not move the horizontal louvres manually.
Always use the AIR DIRECTION or SWING button. If directed manually, malfunctioning may occur.
If louvre malfunctioning occurs, stop the conditioner and re-start it.
•
When the conditioner is switched on immediately after it has been switched off, the horizontal
louvres may not move for approx. 10 seconds.
•
The angle of opening of the horizontal louvres must not be too small, since performance in
COOLING or HEATING mode may not be perfect for the flow of air that is too narrow.
•
Never activate the unit with the horizontal louvres in closed position.
•
When the conditioner is connected to the power supply (initial power supply), the horizontal
louvres may make a noise for 10 seconds. It is normal operation.
3.6- DEHUMIDIFICATION
( figure 34 )
START
Check that the unit is connected and is powered electrically.
a.
Press the “moDe” key (1) to select “DrY” mode.
b.
Set the desired temperature by pressing the “temP” keys (4).
c.
When the remote control is “off”, press the “on/off” key (2) to start the air conditioner.
STOP
a.
Press the “on/off” key (2) to stop the air conditioner.
Fan speed cannot be adjusted when the unit is in AUTO and DRY modes.
3.7 - FTIMER OPERATION
( fig. 33 e 34 )
START
Check that the unit is connected and is powered electrically.
a. Press one of the timer keys (7 and 8) as desired.
the current adjustment of the timer is shown on the display at the side of the timer on and timer off
indicators and will flash.