Oldham olct 80, User Manual

Page: 75 / 120

6
– Operation
69
Chapter 6 | Operation
The operations explained in this section must be performed
by authorized, qualified personnel because they could affect
detection reliability.
Configuring the transmitter
Configure the sensor following the standard steps described in the table below:
Step Description See section See page
1. System date and time. Date and time 22
2. Main sensor. PG sensor 26
3. ANA1 sensor (if used). PG CH1 27
4. ANA2 sensor (if used). PG CH2 30
5. Settings for the main sensor's alarms. AL SENSOR 31
6.
Settings for the #1 input alarms, ANA1 sensor. AL CH1 32
7. Settings for the #2 input alarms, ANA2 sensor. AL CH2 34
8. Conditions triggering the Rel1 relay. RELAIS 1 35
9.
Conditions triggering the Rel2 relay. RELAIS 2 37
10.
Conditions triggering the fault relay. RELAIS D 37
11. Configure the RS485 connection (if used). PG SERIE 38
12. Configure the LCD backlighting. PG SERIE 38
13.
Change the code to access the configuration
menus. PG PASSW 41
14. Zero and calibration gas test for the main sensor. Cal sens. 45
15. Calibration test for the ANA1 sensor (if used). Cal CH1 48
16.
Calibration test for the ANA2 sensor (if used). Cal CH2 48