26
a
b
Figure 36. Start Zero calibration (a
–
b)
After clicking
OK
(see Figure 36 b), the controller will ask for connecting N2 at 1.4 barg to the Air Input,
located on the rear panel of the CO2 CONTROLLER (see Figure 37 a), the Zero Calibration will start after pressing
OK and the progress bar will appear (see Figure 37 b).
Figure 37. Flowrates view (a
–
b).
9.2.1.2.3
Factory Reset
If you are unsure about the calibration you have just performed or if for any reason you want to reset to
the factory calibration, go to the
Sensor Calibration
page and press on Factory Reset icon
.
Figure 38. Sensor calibration factory reset.
