Software
39
7.3 New Scan
Please make sure that your Gepard GPR is powered on and you have enabled the Tablet’s WiFi as described
in section 7.1.3 “Establish a WiFi connection” on page 35. If so, you can start to set up your measurement
now.
7.3.1 Setting up a GPR measurement
After selecting the operating mode “New scan” from the main menu, you have to follow several steps to set
up your application according to your specific task. It all starts with establishing a WiFi connection.
7.3.1.1 Establish WiFi connection
In the first screen from figure 7.7 the application tries to connect to your Gepard GPR. At the same time it
checks for a valid software activation.
If the antennas indicating any problem you should check all connections and cables. When the WiFi
connection has been established successfully, you can push the
button to continue with step 2.
7.3.1.2 General settings
In the second step, shown in figure 7.8, you can adjust general settings that improve or assist your scan
procedure.
OKM GmbH
Figure 7.7: New Scan – Establish WiFi connection
Figure 7.8: New Scan – General settings
