Page: 43
Service Guide OL810e
Chapter 3 Parts Replacement
3.3.21 TQCB-PCB
(1) Remove the operator panel assy (see 3.3.4).
(2) Remove the upper cover assy (see 3.3.1).
(3) Remove the face up stacker assy (see 3.3.7), and shield plate.
(4) Remove the connector (PSIZE) (2NDTRAY) 5 and 6, LED Head cables, and motor connectors.
(5) Remove three screws 1.
(6) Move the TQCB-PCB 2 in the direction of arrow to disconnect it from the power supply/sensor board
3.
(7) Remove the TQCB-PCB 2, together with the PCB guide plate (remove the fan motor 4 at the same
time).
(8) Remove the connector CN1, and disconnect the fan motor 4.
(9) Remove three screws 8 and two nuts 9, and remove the PCB guide plate 7 from the TQCB-PCB 2.
Note: When reinstalling the TQCB-PCB 2 onto the base plate 7, be careful not to bend the base plate (it is
desirable to place a block underneath it to prevent bending).
Summary of Contents for OL810e
