43471801TH Rev.1
33 /
Oki Data CONFIDENTIAL
Head clamp
A
1
3
2
Pull-up cover
Figure 1
Figure 2
3.3.2 Printhead
(1)
Open the access over.(See. 3.3.1)
(2)
Open the pull-up roller cover.
(3)
Remove the cable cover
1
.
(4)
Pull up and rotate the head clamp to unclamp the printhead
2
as shown Figure 1.
(5)
Disconnect the printhead
2
from Flat cable
3
.
(6)
Assemble in the reverse order of disassembly.
Notes :
(1)
Insert the printhead
2
into the Flat cable
3
while pushing it against the carriage
frame (be careful not to damage cables when attaching the flat cables).
(2)
The head clamp must surely be sandwiched between printhead
3
and carriage frame
as shown Figure 2.
(3)
Be sure to check the gap between platen and printhead (see 4).
(4)
Be careful not to touch the print head while it is very hot.
(5)
Make sure that there is not any dust or oil on the connector contact section A. If it
is found, wipe it off by alcohol.
Head clamp
2
2
Head clamp
Carrige frame
