41356801TH Rev.1
108 /
6
Prints voids
• Is the contact plate of the transfer roller in proper contact with the power supply/sensor board (see
Figure 6-5)?
• No
Adjust the contact plate so that it touches the power supply/sensor board and the shaft
of the transfer roller properly.
• Yes
Replace the transfer roller.
• Has the problem been solved?
• Yes
End
• No
Is the tension between the back-up roller (7.52kg) and the surface of back-up roller normal?
• No
Replace the back-up roller or bias spring.
• Yes
Are the contacts of the toner supply roller, developing roller, image drum and charging roller
in proper contact with the contact assy (see Figure 6-4
A
,
B
,
C
,
D
,
E
)?
• No
Adjust the contacts so that they touch the contact assy properly.
• Yes
Replace the image drum cartridge.
• Has the problem been solved?
• Yes
End
Note:
After replacing the image drum cartridge, set the printer in the user maintenance
mode by turning the power on while pressing the MENU key, and reset the drum
counter (see Printer Handbook).
• No
Is the LED head being installed properly (check HEAD1 and HEAD 2 connectors on the main
control board and PC Connector on the LED head)?
• No
Install the LED head properly.
• Yes
Replace the LED head or the head cable(s).
• Has the problem been solved?
• Yes
End
• No
Replace the main control board or power supply/sensor board.
Summary of Contents for OKIPAGE 14
