Oki MSM85C154HVS, User Manual

Page: 111 / 378

MSM80C154S/83C154S/85C154HVS
104
4.6.2.5 SMOD
SMOD controls the division of the baud rate clock source when the serial port is in UART mode
(mode 1, 2, or 3).
If SMOD is cleared when in mode 1 or 3, the timer/counter 1 overflow frequency divided by
2 becomes the baud rate clock source. And if SMOD is set, the timer/counter 1 overflow
becomes the baud rate clock source.
When TCLK is set in mode 1 or 3, however, and timer/counter 2 is the baud rate clock source
for the transmitting circuit, SMOD has no effect on the transmitting baud rate. And if RCLK
has been set, timer/counter 2 becomes the baud rate source for the receiving circuit, and
SMOD has no effect on the receiving baud rate.
If SMOD is cleared in mode 2, 1/2 OSC (oscillator frequency divided by 2) divided by 2
becomes the baud rate clock source. And if SMOD is set, 1/2 OSC becomes the baud rate
clock source.
SMOD is located at bit 7 of PCON (power control register) specified by data address 87H.
Designation by bit address is not possible.
See Table 4-17 for the corresponding baud rate clock sources for TCLK, RCLK, and SMOD.
Table 4-17 Corresponding baud rate clock sources for TCLK, RCLK, and SMOD
Mode TCLK or RCLK SMOD Baud rate colck source
0 X X MSM83C154S fundamental timing
0 0 T/C1 overflow divided by 2
1 0 1 T/C1 overflow
1 X T/C2 overflow
2
X 0 1/2 OSC divided by 2
X 1 1/2 OSC
0 0 T/C1 overflow divided by 2
3 0 1 T/C1 overflow
1
Note: X
T/C1
T/C2
1/2 OSC
: Don't care
: Timer/counter1
: Timer/counter2
: Oscillator frequency (XTAL1•2) divided by 2
X T/C2 overflow