Oki Microline Ml184T+, Handbook, Page: 51 / 117

Operating Your Printer 2 -- 29
Installation of the Cut-Sheet Feeder
Select “CSF” at the “CSF/RPS Select” menu option.
1. Remove the acoustic cover, tractor feed unit, and paper separator if
installed.
2. Remove the access cover.
3. Pull the column indicator away from the platen and push the pressure
rollers to the left and the right end of the bar.
4. Fit the cut-sheet feeder clamps over the platen collar and lower on to
the printer.
Notes: 1. Move the front sheet guide of the cut-sheet feeder under the column indicator.
Gently push the front sheet guide towards the platen, then close the column indica-
tor. To engage it with the front sheet guide hook, pull it back to open position.
2. Turn the platen knob to make sure the coupling gear on the left-hand side of the
cut-sheet feeder are in line with the platen gear.
Coupling gear
Platen gear
Platen collar
5mm
Pressure roller
Pressure roller
Platen collar
Clamp
Front sheet guide
Column indicator bar
5. Insert the sheet supports. Fit the slotted ends of the narrow sheet sup-
port on to the square bar and paper chute on to either side of the mid-
dle paper guide at the rear of the cut sheet feeder. Slide the front sheet
support into the tracks between the feed rollers and the metal plate.