Oki Microline Ml184T+, Handbook, Page: 14 / 117

1 -- 8 Setting Up
c. Close the paper release lever.
d. Turn the platen knob clockwise away from you to pull the paper
around the platen and behind the Bail bar.
e. Move the Bail bar back on to the platen so that the rollers rest on
the paper you have just inserted.
10. Advance the paper, using the platen knob, until 1 inch of paper ap-
pears above the Bail bar.
11. Replace the access cover:
a. Insert the three tabs in the edge of the access cover into the holes
on the top front edge of the printer.
b. Lower the access cover on to the printer.
12. Grasp the paper and pull it through the opening in the access cover.
Use the platen knob if you need more paper.
13. Insert the connector end of the power cord into the socket at the rear
of the printer.
14. Make absolutely certain that the ON/OFF power switch on the side of
the printer is OFF. (A sudden power surge can damage the printer.)
15. Plug the power cord into a earthed (three-pronged) electrical socket.
Important: The printer must be earthed at all times.