Oki LP441b, Manual Rapide

Page: 59 / 152

59
Lorsque vous utilisez un rouleau de papier de la même largeur que
le rouleau utilisé antérieurement, il n’est alors pas nécessaire de
régler les guides-papier .
➎
Fermez le capot une fois le
bord d’attaque du rouleau
d’étiquettes à l’extérieur
de l’imprimante (plus de
10 mm) .
Lorsque des étiquettes sans
interstices sont utilisées, appuyez
sur le bouton ALIMENTATION pour
faire sortir un bout d’étiquette de
l’imprimante et le tirer vers le haut
pour couper l’étiquette le long des
perforations .
Si l’étiquette se bloque,
effectuez à nouveau la procédure
d’installation des étiquettes .
➏
Coulissez l’unité de
distribution jusqu’à
butée .
L’installation des étiquettes pour l’impression en mode
distribution est terminée .
Before Starting
4
28
Turning Printer On
5
29
5. Turning Printer On
After the procedure mentioned before has been finished, try
to turn the printer power on and off.
1
Press and hold the
POWER key. When the
STATUS LED lights
green, release the key.
2
Press and hold the
POWER key again.
When he STATUS LED
goes off, release the
key..
POWER
PRINT
FEED
POWER
PRINT
FEED
5
Close the cover after
confirming that the
leading edge of the
label is outside the
printer (more than 10
mm).
When using a non-separate
label, press FEED key to
feed a piece of label and pull
the label upward to cut it
along the perforation.
If the label is jammed, retry
label setting procedure.
6
Slide the dispenser unit
until it stops.
This completes the label setting in the Dispense mode.
•
To changing Dispense mode to continuous
mode
Lifting the change lever,
slide the dispenser unit
until stops.
Bord d’attaque du rouleau
d’étiquettes
Before Starting
4
28
Turning Printer On
5
29
5. Turning Printer On
After the procedure mentioned before has been finished, try
to turn the printer power on and off.
1
Press and hold the
POWER key. When the
STATUS LED lights
green, release the key.
2
Press and hold the
POWER key again.
When he STATUS LED
goes off, release the
key..
POWER
PRINT
FEED
POWER
PRINT
FEED
5
Close the cover after
confirming that the
leading edge of the
label is outside the
printer (more than 10
mm).
When using a non-separate
label, press FEED key to
feed a piece of label and pull
the label upward to cut it
along the perforation.
If the label is jammed, retry
label setting procedure.
6
Slide the dispenser unit
until it stops.
This completes the label setting in the Dispense mode.
•
To changing Dispense mode to continuous
mode
Lifting the change lever,
slide the dispenser unit
until stops.