131
Não é preciso ajustar a guia de etiquetas quando o papel usado
tiver a mesma largura do papel usado anteriormente .
➎
Feche a tampa depois de
confirmar que a borda do
rolo de etiquetas está para
fora da impressora (mais
de 10 mm) .
Ao usar etiquetas não separadas,
pressione o botão FEED para
avançar um pedaço da etiqueta e
puxe-o para cima para cortá-lo ao
longo da perfuração .
Se a etiqueta estiver atolada na
impressora, retire-a e recoloque-a
novamente .
➏
Deslize a unidade
dispensadora até que
pare .
Isso conclui as instruções de colocação de etiquetas no
modo de dispensa .
Before Starting
4
28
Turning Printer On
5
29
5. Turning Printer On
After the procedure mentioned before has been finished, try
to turn the printer power on and off.
1
Press and hold the
POWER key. When the
STATUS LED lights
green, release the key.
2
Press and hold the
POWER key again.
When he STATUS LED
goes off, release the
key..
POWER
FEED
POWER
FEED
5
Close the cover after
confirming that the
leading edge of the
label is outside the
printer (more than 10
mm).
When using a non-separate
label, press FEED key to
feed a piece of label and pull
the label upward to cut it
along the perforation.
If the label is jammed, retry
label setting procedure.
6
Slide the dispenser unit
until it stops.
This completes the label setting in the Dispense mode.
•
To changing Dispense mode to continuous
mode
Lifting the change lever,
slide the dispenser unit
until stops.
Borda do rolo de etiquetas
Before Starting
4
28
Turning Printer On
5
29
5. Turning Printer On
After the procedure mentioned before has been finished, try
to turn the printer power on and off.
1
Press and hold the
POWER key. When the
STATUS LED lights
green, release the key.
2
Press and hold the
POWER key again.
When he STATUS LED
goes off, release the
key..
POWER
FEED
POWER
FEED
5
Close the cover after
confirming that the
leading edge of the
label is outside the
printer (more than 10
mm).
When using a non-separate
label, press FEED key to
feed a piece of label and pull
the label upward to cut it
along the perforation.
If the label is jammed, retry
label setting procedure.
6
Slide the dispenser unit
until it stops.
This completes the label setting in the Dispense mode.
•
To changing Dispense mode to continuous
mode
Lifting the change lever,
slide the dispenser unit
until stops.
Summary of Contents for LP441b
