38
en
The following things should be checked before starting the dishwasher.
The dishwasher is level and fixed properly
1.
The inlet valve is open
2.
There is a leakage at the connections of the conducts
3.
The wires are tightly connected
4.
The power is switched on
5.
The inlet and drain hoses are knotted
6.
All packing materials and printings should be taken out from the dishwasher
7.
sTarT OF Dishwasher
After installation, please make sure to keep this manual. The content of this manual is very helpful to the users.
aTTenTiOn:
beFOre callinG FOr serVice
Review the charts on the following pages may save you from calling for service.
TOubleshOOTinG TiPs
PrObleM
POssible causes
whaT TO DO
Technical
problems
Dishwasher
doesn't start
Fuse blow, or the
circuit breaker acted
Replace fuse or reset circuit breaker. Remove any other
appliances sharing the same circuit with the dishwasher.
Power supply is not
turned on
Make sure the dishwasher is turned on and the door is
closed securely.
Make sure the power cord is properly plugged into the
wall socket.
Water pressure is low Check that the water supply is connected properly and
the water is turned on.
Door of dishwasher
not properly closed
Make sure to close the door properly and latch it.
Water not pumped
from dishwasher
Kink in drain hose
Check drain hose.
Filter clogged
Check coarse the filter (see section "Cleaning the filter")
Kitchen sink clogged
Check the kitchen sink to make sure it is draining well. If
the problem is the kitchen sink not draining, you may
need a plumber rather than a serviceman for dishwash-
ers.
General
problems
Suds in the tub
Improper detergent
Use only the special dishwasher detergent to avoid suds.
If this occurs, open the dishwasher and let suds
evaporate. Add 1 gallon of cold water to the tub. Close
and latch the dishwasher, then Start any wash cycle to
drain out the water.
Spilled rinse-aid
Always wipe up rinse-aid spills immediately.
Stained tub
interior
Detergent with
colourant was used
Make sure that the detergent is the one without
colourant.
White film on
inside surface
Hard water minerals
To clean the interior, use a damp sponge with
dishwasher detergent and wear rubber gloves. Never
use any other cleaner than dishwasher detergent for the
risk of foaming or suds.
There are rusty
stains on cutlery
The affected items
are not corrosion
resistant
A programme was
not run after
dishwasher salt was
added. Traces of salt
have gotten into the
wash cycle.
Always run the quick wash programme without any
crockery in the dishwasher and without selecting the
Turbo function (if present) after adding dishwasher salt.
The lid of the softer is
loose
Check the lip. Ensure the fix is fine.
