27
en
Always use the salt intended for use with dishwasher.
The salt container is located beneath the lower basket and should be filled as explained in the following:
aTTenTiOn!
Only use salt specifically designed for the use in dishwashers! Every other type of salt not specifically designed for
•
the use in a dishwasher, especially table salt, will damage the water softener. In case of damages caused by the
use of unsuitable salt the manufacturer does not give any warranty nor is liable for any damages caused.
Only fill with salt just before starting one of the complete washing programs. This will prevent any grains of salt or
•
salty water, which may have been spilled, remaining on the bottom of the machine for any period of time, which
may cause corrosion.
lOaDinG The salT inTO The sOFener
Remove the lower basket and then unscrew and remove the cap from the salt container (1).
A
Place the end of the funnel (supplied) into the hole and introduce about 1.5kg of dishwasher salt (2).
B
Full fill the salt container with water.It is normal for a small amount of water to come out of the salt container.
C
After filling the container , screw the cap tightly back clockwise.
D
Usually, the salt warning light will stop being illuminated within 2-6 days after the salt container has been filled with
E
salt.
Immediately after filling the salt into the salt container, a washing program should be started (We suggest to use the
F
soak or rapid program). Otherwise the filter system, pump or other important parts of the machine may be
damaged by salty water. This is out of warranty.
The salt container must only be refilled when the salt warning light in the control panel comes on. Depending on
1.
how well the salt dissolves, the salt warning light may still be on even though the salt container is filled. If there is
no salt warning light in the control panel (for some Models), you can estimate when to fill the salt into the softener
by the cycles that the dishwasher has run.
If there are spills of the salt, a soak or a rapid program should be run to remove the excessive salt.
2.
nOTe:
