OCS SOFTWARE
OJMAR
7
3.3.1.3 Lock initialisation operation
This operation configures the lock with the data stored in the key that have previously been downloaded from the PC software (lock
number, lock type, alarms, time details...).
Follow the steps indicated below:
1.
Make the "Connection".
If all the foreseen locks have already been programmed, the LED will light up in red instead of in GREEN, indicating error
code 4 and no actions will be carried out on this lock.
2.
Enter the sequence “start” +
+ 0 +
to start to programme the lock. This sequence should be entered before
starting to download events.
3.
If the sequence is not correctly entered or the key is removed to soon, the LED will flash in red indicating error code 3.
If the programming key has a low battery, the LED will light up in red instead of in green, indicating error code 2 and no
actions will be carried out on the lock.
4.
If the lock initialisation has gone well, the green LED will flash indicating that the key can now be removed.
3.3.1.4 Lock deletion operation
This operation deletes all the data in the OCS lock, leaving it in the same status as when it left the factory.
a)
Make the "Connection"
If the programming key has a low battery, the LED will light up in amber instead of in green, indicating error code 2 and
no actions will be carried out on the lock.
b)
Before starting to download events, enter the sequence “start” +
+ 1 +
to start to delete the lock.
Deletion will take a few seconds, and the LED will remain turned on in red while this operation is being carried out.
c)
If the deletion has been carried out correctly, the green LED will flash indicating that the key can now be removed.
3.3.2 Operations with programming key configured as master key
A programming key configured as a master key allows activating an OCS lock when it is locked. It therefore allows opening a
locker and then closing it again, leaving it in the same condition as it was before.
If the lock is configured as free it will open and close depending on its status (if it is closed or open).
If, on the contrary, the lock is configured as dedicated (normally closed), the master key will open the OCS and a few seconds later,
the OCS will automatically close.
The steps to follow to use a master key are the same as those carried out in the "Connection" command:
a)
Turn the lock on pressing “start”
b)
Press the button on the programming key.
3.3.3 Operations with programming key configured as user key
The programming key can be configured as a user key, replacing having to manually enter the numeric code using the keypad.
The steps to follow to use a user key are the same as those carried out in the "Connection" command:
a)
Turn the lock on pressing “start”
b)
Press the button on the programming key.
