OCS SOFTWARE
OJMAR
3
3.1.3. OCS manual locking fixed mode
The OCS lock operating in manual locking fixed mode will open entering a preset numeric code, preset by the facility's staff. This
lock only opens with the combination of numbers assigned to each lock.
Manual locking fixed OCS are normally closed, and the following steps should be used to open them:
1.
Press “start” to wake the lock up.
2.
Enter the assigned code into the keypad.
3.
Press
4.
The lock opens. To close follow the same steps as for opening. It can only be locked with the code assigned to the lock.
3.1.3.1 Assignment and/or change of the code in dedicated locks
Tras inicializar una cerradura en modo fijo ésta no se puede accionar ya que no tiene ningún código de apertura almacenado en su
memoria. Para grabar por primera vez el código de apertura o para cambiar el existente por uno nuevo se debe introducir por
teclado la siguiente combinación numérica.
1.
Press “start” to wake the lock up.
2.
Enter the assigned code into the keypad.
3.
New code
4.
Press
Or in other words: the lock must be turned on pressing the “start” button. After that, enter the master code programmed on
initialising, after it the new code will be 4, 5 or 6 digits depending on the configuration of the lock and to finish the sequence press
the padlock key.
After carrying out this sequence the new opening code will be programmed in the lock.
3.1.4. OCS free mode with coin
The OCS lock in free mode with coin operates in the same way as in the free mode, and the only difference is that a coin has to be
inserted in the slot designed for this purpose to activate it.
The lock will not close if it is open and no coin has been inserted.
If the lock is closed and the coin is removed, the lock will automatically open when the “start” key is pressed.
The procedure is the same as above for the free mode (see
Section 2.1.1
)
