－
10
－
５－３．
Adjusting the brush height
Load the screws into the scooping hopper, turn ON and OFF the
power switch so that screws are alligned into the rail groove.
・
Turn ON and OFF the power switch in order to set the brush to
the left as shown in the figure on the right.
・
Move the brush by hand to check that the screws, in the rail
groove, are in slight contact with the brush bristles and if needed
make the necessary adjustments.
・
When the brush height is too high or low, this will have an
adverse effect on the screw allignment and transport.
・
If any adjustment is necessary, loosen the brush height
adjusting bolt to adjust the brush height.
・
If the plastic portion, at the front of the brush, comes into contact
with the passing plate, loosen the brush assembly mounting
screw and move the brush assembly back so there is 0 mm
clearance.
・
Turn ON the power switch to check that the brush operation is
normal.
Turn OFF the power switch before starting replacement and
adjustment.
Brush
Loaded screws
Brush height adjusting bolt
Move the brush by hand to check that the screws, in the
rail groove, are in slight contact with the brush bristles
and make adjustments if necessary.
Turn On and Off the power switch to put the brush
bristles in a horizontal position towards the left
side.
Brush assembly
attaching screw
Summary of Contents for OM-26RB Series
Page 23: ...22...
