－
31
－
Trouble
Cause
Corrective Measure
Screws tend to pass
through the passing plate in an ab-
normal position.
The axis of the screw thread tends to
enter the passing plate.
・
The passing plate is not adjusted
properly.
・
Too many screws are in the scooping
hopper.
・
Adjust the passing plate.
・
Reduce the quantity of screws to
a proper level.
No screw flows to the pick up spot.
・
Screws are stopped while still on the
rail.
・
Screws cannot be transferred smoothly
from the rail to the escaper.
・
Adjust the position of the holding
plate.
・
Adjust the distance between the end
of the rail and the escaper.
The machine stops its operation suddenly.
・
The overload protective circuit was
activated.
・
Too many screws are in the scooping
hopper.
・
A screw is caught in the clearance.
・
A screw at the pick up spot, could not
be picked up for an amount of time.
・
Turn the machine OFF and then ON
again.
・
Remove the cause of overload.
・
Remove screws to a proper level.
・
When the machine stops, even if the
screws are at a proper level, consult
our service section.
・
Remove the screw that is caught.
・
Remove the screw.
Summary of Contents for OM-26R Series
Page 43: ...42...
