－
12
－
５－５．
Check and adjust the front and rear sides of the rail
５－６．
Check and adjust the rear hopper cover
Turn OFF the power switch before starting replacement and
adjustment.
Turn OFF the power switch before starting replacement and
adjustment.
Rail fixing bolt
Hold the rail groove and adjust the rail
assembly either backward or forward.
The rear hopper cover attaching bolts
The clearance between
the rear hopper cover and
the rail assembly is about
0.2mm
Scraper
・
If the rail comes into contact with the escaper, or the clearance between the
rail and escaper is too large, loosen the rail fixing bolt, hold the rail groove
and adjust the rail assembly either backward or forward. After making an
adjustment, be sure to tighten the rail fixing bolt.
・
When the rail comes in contact with the escaper, the escaper disk doesn't
rotate properly. When the clearance between the rail and the escaper is too
large, screws may fall down into the machine.
・
After making an adjustment, try making a vibration readjustment by referring to
" 5-4 Checking and Adjusting the Rail Vibration".
・
Check that the clearance between the rear hopper cover and the rail
assembly is about 0.2 mm.
・
If the rail hits against the rear hopper cover, the vibration will become weak
and the screws will be delivered slowly. If the rear hopper cover is too high,
the slit between the rail and the scraper catches screws easily.
・
If adjustment is required, loosen the rear hopper cover attaching bolts and
make an adjustment either up or down.
Summary of Contents for OM-26R Series
Page 43: ...42...
