－
12
－
５）
OPERATING INSTRUCTIONS
◆
Supplying screws
(Refer to P. 4)
* Set the [scooping block] to the lowest possible position. Remove the top cover of the [scooping chamber]. Throw in
screws up to a position of 2 mm to 3 mm below the rail groove top face.
* In this condition, ensure that the front inclined-face of the ramp is not hidden by the screws.
Caution:
An excessive quantity of screws thrown in may cause a machine malfunction.
◆
Switch-on
* Plug the provided AC adapter into a wall outlet and into the machine.
* Turn on the power switch. The power switch lamp will light up.
* The up-and-down movement of the scooping block and back-and-forth movement of the rail will activate.
* Subsequently, screws are successively sent to the outlet direction. Unless you pick up the screws in the stopper
section, the sensor senses it and the machine stops operation.
* If you pick up the screws in the stopper section, the sensor senses it and the machine resumes operation.
◆
Picking up screws
* When picking screws up, use a bit that fits the screw diameter and groove width of the holding plate.
* Make a motor-driven driver’s bit upright, put it down to the vertical direction along the V groove of the bit guide while
turning it, and pull it out toward yourself when cross recess on the screw head is pick up by the bit.
Caution:
Do not exert any excessive force to the rail at this time. It may cause the machine to malfunction.
◆
Timer settings
（
Refer to P. 11
）
* If you pick up screws of the stopper section and then do not pull up the next screws for a certain period of time, the
machine stops. Operation will resume again after you pick up screws.
* The time until the machine stops is adjustable within 1 to 6 seconds. Adjust it according to the procedure in the
diagram on the right.
Caution:
Always unplug the AC adapter from the wall outlet before making any adjustments to avoid injury.
