－
9
－
◆
Adjustment of the tilting bolts
- As the original setting, the automatic screw feeder shall be horizontal
when set on a surface.
Depending on specific type of screw applied, there may be cases that
the screws cannot move smoothly. At such instance, please check the
“Adjustment of the rail” section listed in this operation booklet, or adjust
tilting angle of the machine as necessary:
- The tilting bolts are located on bottom rear end of the machine.
- When these bolts are used, they shall be set at the same height and angle
on both sides.
- Since the bolts do not have stoppers equipped inside, please be careful
not to detach them from the machine body.
- After the adjustment, please verify if screw delivery functions properly
before application.
◆
Check/adjustment of rail vibration
Transfer speeds of screws differ according to screw type.
This machine can change rail amplitude and adjust the transfer speed.
* To adjust amplitude, loosen an amplitude fixing screw at the rear of
this machine and turn the amplitude adjusting screw at the bottom of
the machine.
Viewing it from the bottom, if turned clockwise, the amplitude becomes
larger, and if turned counterclockwise, the amplitude becomes smaller.
* If you make the amplitude too large in order to speed up the transfer,
it may become difficult to pull up screws. So, adjust it to appropriate
amplitude for the type of screw being used.
* After adjustment is completed, be sure to tighten the amplitude fixing
screw on the rear of the machine.
Tilting bolt
・ Loosen the tilting bolts, to
adjust angle of the machine.
・ Keep both sides as the
same height.
Amplitude
fixing screw
Larger vibration
Smaller vibration
Amplitude
(Vibration)
adjusting
screw
